Appendix C. Glossary
Acronyms and terms used in the tutorial, with the chapter where each is introduced.
| Term | Meaning | Chapter |
|---|---|---|
| α-factor | Linewidth-enhancement factor: the ratio of index to gain change with carrier density in a semiconductor laser | 25 |
| APD | Avalanche photodiode: a photodiode with internal gain by impact ionisation | 21 |
| ASE | Amplified spontaneous emission: the noise added by an optical amplifier | 28 |
| AWG | Arrayed-waveguide grating: a dispersive multiplexer | 14 |
| BER | Bit-error ratio | 21 |
| BOX | Buried oxide: the SiO₂ layer under the silicon film of an SOI wafer | 4 |
| BTO | Barium titanate (BaTiO₃): a Pockels material integrated on silicon | 4 |
| C band, O band | Telecom bands near 1530–1565 nm and 1260–1360 nm | 1 |
| CMOS | Complementary metal–oxide–semiconductor: the process technology of microelectronics | 1 |
| CPO | Co-packaged optics: photonics in the same package as a switch or processor | 17, 33 |
| CWDM, DWDM | Coarse (20 nm) and dense (ITU grid) wavelength-division multiplexing | 14 |
| DBR, DFB | Distributed Bragg reflector and distributed-feedback lasers | 26 |
| DFM, DFT | Design for manufacturing; design for test | 29, 17 |
| DRC | Design-rule check | 30 |
| DUV | Deep-ultraviolet (248 and 193 nm) projection lithography | 29 |
| EAM, EML | Electro-absorption modulator; electro-absorption modulated laser | 20 |
| EBL | Electron-beam lithography | 29 |
| EDFA | Erbium-doped fibre amplifier | 28 |
| EME | Eigenmode expansion: a propagation solver | 30 |
| ER | Extinction ratio | 20 |
| FDTD | Finite-difference time-domain simulation | 30 |
| FEC | Forward error correction | 21 |
| FMCW | Frequency-modulated continuous-wave ranging (LiDAR) | 34 |
| FSR | Free spectral range | 11, 12 |
| FWHM | Full width at half maximum | 12 |
| GC | Grating coupler | 15 |
| GDS | The standard file format for layouts | 30 |
| IM-DD | Intensity modulation with direct detection | 33 |
| IQ modulator | Two nested MZMs that write the in-phase and quadrature parts of the field | 20 |
| KP4 | The Reed–Solomon FEC code of high-speed Ethernet (threshold BER about 2.4 × 10⁻⁴) | 21 |
| LIV | Light–current–voltage characteristic of a laser | 24 |
| LOD | Limit of detection | 34 |
| MFD | Mode-field diameter (1/e² intensity) | 3 |
| MMI | Multimode-interference coupler | 10 |
| MPW | Multi-project wafer run | 29 |
| MQW | Multiple quantum wells | 23 |
| MZI, MZM | Mach–Zehnder interferometer and modulator | 11, 20 |
| neff, ng | Effective index (phase) and group index (energy, envelope) | 5, 6 |
| NRZ, PAM4 | Two-level and four-level intensity modulation | 20 |
| OMA | Optical modulation amplitude | 1 |
| OPA | Optical phased array | 34 |
| PDK | Process design kit | 30 |
| PIC | Photonic integrated circuit | 1 |
| PM fibre | Polarisation-maintaining fibre | 17 |
| PSR | Polarisation splitter-rotator | 14 |
| Q | Quality factor of a resonance: λ/ΔλFWHM; loaded QL and intrinsic Qi | 12 |
| RIN | Relative intensity noise | 25 |
| RIU | Refractive-index unit (sensor sensitivity in nm/RIU) | 34 |
| SMF-28 | The standard single-mode telecom fibre (mode-field diameter 10.4 µm at 1550 nm) | 3 |
| SMSR | Side-mode suppression ratio | 26 |
| SOA, RSOA | Semiconductor optical amplifier; reflective SOA (gain chip of an external-cavity laser) | 28, 26 |
| SOI | Silicon-on-insulator | 4 |
| SWG | Subwavelength grating | 13 |
| TE, TM | Transverse-electric and transverse-magnetic modes | 5 |
| TFLN | Thin-film lithium niobate | 4 |
| TIA | Transimpedance amplifier | 21 |
| UHNA fibre | Ultra-high numerical aperture fibre, with a small mode (3–4 µm) | 16 |
| VπL | Voltage–length product of a phase shifter | 19 |
| WDM | Wavelength-division multiplexing | 14 |